![]() ![]() One thing that's strange about these last three commands: Under "Windows Boot Loader," both "device" and "osdevice" say "partition=E:" and when I use those first two commands to change them to the C: drive (which I assume is what they're supposed to be, since that's where my OS is), it works. I've tried all the command prompt commands that are recommended here, including:īcdedit /set device partition=c: I have connected this camera successfully in the past, for what it's worth. I'm not sure if that has anything to do with what's causing this, but it's the only thing I can think of. It said it was installing the device, but when it was finished my computer wouldn't detect the camera, so I rebooted to see if that would help. ![]() Whenever I try to boot up my computer, it gets stuck in a repair loop with a BSOD and the error "INACCESSIBLE_BOOT_DEVICE." This problem started after I connected my DSLR camera to transfer some photos. ![]() Western Digital Caviar Blue 1TB 3.5" 7200RPM Internal Hard Drive Kingston SSDNow V300 Series 120GB 2.5" Solid State Disk Intel Core i5-3570K 3.4GHz Quad-Core ProcessorĬrucial Ballistix Sport 8GB (1 x 8GB) DDR3-1600 Memory
0 Comments
Leave a Reply. |